trois code d'erreur

p1633 sa dit manufacturer contrl
auxiliary input
auxiliary output
p0172
system too rich
(bank 1)
p0175
system too rich
(bank 2)

quelle quun peut me donner une piste

[rj240]

P1633 = ECM-510F - Speed signal
Possible source
Signal too high / low:
defective vehicle speed signal to the ABS / brake control module (BCM) A diagnostic trouble code (DTC) is stored in the ABS / brake control module (BCM).
Signal missing:
contact resistance in the Controller area network (CAN) terminals
open-circuit in one or both CAN cables
one or both signal cables short-circuited to ground, voltage or each other
defective ABS / brake control module (BCM)
defective engine control module (ECM).

P0172 = ECM-262A - Long term fuel trim, lower limit
Possible source
intake air leakage
high fuel pressure
leaking injectors
defective mass air flow (MAF) sensor
contaminated engine oil
oil level too high
defective heated oxygen sensor (HO2S)

P0175 = ECM-272A - Long term fuel trim, bank 2, lower limit
Possible source
intake air leakage
high fuel pressure
leaking injectors
defective mass air flow (MAF) sensor
contaminated engine oil
oil level too high
defective heated oxygen sensor (HO2S

[blackchrome]

Le premier code sa serai une module ABS a changer

Les autre avant l'hiver j'ai installer un p-flow de cher canadien tire javais seulment le code p1633 a installation depuis une semaine j'ai les deux nouveau le p-flow serai t'il mon probleme